Let me introduce to you from the following three aspects:

(1) The feeding speed is too fast, the load increases, causing blockage

During the feeding process, pay attention to the large deflection angle of the ammeter pointer at any time. If it exceeds the rated current, (if it is a product without an ammeter, pay attention to the sound of the machine head and the motor working normally, and abnormal noise occurs), indicating that the motor is overloaded and overloaded for a long time. , it will burn out the motor. In this case, the material gate should be reduced or closed immediately, and the feeding method can also be changed, and the feeding amount can be controlled by increasing the feeder. There are two kinds of feeders: manual and automatic. Users should choose the appropriate feeder according to the actual situation. Due to the high speed of the universal pulverizer, the large load, and the strong fluctuation of the load. Therefore, the current of the pulverizer is generally controlled at about 85% of the rated current.

(2) The discharge pipe is not smooth or blocked

If the feed is too fast, the tuyere of the universal pulverizer will be blocked; improper matching with the conveying equipment will cause the discharge pipeline to be weakened or blocked after no wind; if the bag is dust-removed, if you do not pay attention to cleaning the bag regularly, it will also easily cause the air volume of the induced draft fan. Block after weakening or no wind. After the fault is found, the unmatched conveying equipment should be cleared first, and the feeding amount should be adjusted to make the equipment operate normally.

(3) The claws or hammers are broken, aged, the screen holes are closed and broken, and the water content of the crushed materials is too high, which will cause the universal crusher to block.

Broken and severely aged claws or hammers should be regularly updated to keep the pulverizer in good working condition, and the screen should be checked regularly. The moisture content of the pulverized materials should be lower than 14%, which can not only improve production efficiency, but also make universal pulverization. The machine is not blocked, and the reliability of the pulverizer is enhanced.